加拿大28组合算法公式

新闻资讯

煤泥烘干机出现不能点燃的情况是怎么回事?

2019-12-18 来源:http://www.xezaja.cn 发布人:众焱小编 浏览量:
[导读]:  矿泥干燥机是用来干燥矿泥的设备,其性能优势并不多说,大家都比较了解,在市场上矿泥干燥机的销量在逐渐增加,有时会出现供不应求的现
  矿泥干燥机是用来干燥矿泥的设备,其性能优势并不多说,大家都比较了解,在市场上矿泥干燥机的销量在逐渐增加,有时会出现供不应求的现象,所以投资矿泥干燥机也是不错的选择。
  Slime dryer is used to dry slime equipment, its performance advantage is not much said, we all know that in the market, the sales volume of slime dryer is gradually increasing, sometimes there is a phenomenon of supply exceeding demand, so investment in slime dryer is also a good choice.
  同时,煤泥烘干机是干煤泥中的水加热热源的燃烧炉,所以在运行煤泥干燥机之前完全准备点火,但有时客户会遇到煤泥烘干机燃烧炉不能点燃这一现象,为什么这种情况呢?
  At the same time, the slime dryer is the combustion furnace of water heating heat source in the dried slime, so it is fully prepared to ignite before running the slime dryer, but sometimes customers will encounter the phenomenon that the combustion furnace of the slime dryer cannot ignite, why is this situation?
  事实上,不同类型的煤泥烘干机与煤炉是不同的,不同类型的煤炉上燃料煤炭的需求是不同的,所以需要选择不同的燃料根据不同类型的煤炉,否则将导致煤炭燃烧的现象不上升,引起热的现象并不是标准。
  In fact, different types of slime dryers and coal stoves are different, and the demand for fuel coal on different types of coal stoves is different, so different fuels need to be selected according to different types of coal stoves, otherwise the phenomenon of coal combustion will not rise, and the phenomenon of heat is not the standard.
  和不同类型的煤的适应性也不同,所以客户应提供煤特点选择合适的炉型,流化床是更好的适应性,同时,热风炉的生产成本较低,和煤粉炉的要求较多,但相对较高的热效率,能耗低,所以顾客会根据自己选择合适的设备。
  The adaptability to different types of coal is also different, so customers should choose the right furnace type based on the characteristics of coal. Fluidized bed is better adaptability. At the same time, the production cost of hot blast furnace is lower, and the requirements of pulverized coal furnace are more, but relatively high thermal efficiency and low energy consumption, so customers will choose the right equipment according to their own.
木屑烘干机厂家
  如果点火时间长,热供应慢,可能是由于前期工作没有到位。如燃烧状态和燃烧引燃材料层厚度等都是需要注意的,如流化床对于板子燃烧后没有明显的火焰形成时,煤层厚度为180-200 - mm厚。
  If the ignition time is long and the heat supply is slow, it may be because the preliminary work is not in place. For example, the combustion state and the thickness of the material layer of the combustion pilot need to be noted. For example, when there is no obvious flame formation after the combustion of the plate in the fluidized bed, the thickness of the coal seam is 180-200-mm.
  如不存在上述问题,则应考虑是否由火眼故障、风量过大、点火电极故障、点火变压器故障、电磁阀故障等引起,需要技术人员进一步检查排除。
  If there is no such problem, it shall be considered whether it is caused by fire hole fault, excessive air volume, ignition electrode fault, ignition transformer fault, solenoid valve fault, etc., which need to be further checked and eliminated by technical personnel.
返回顶部

版权所有©山东众焱机械有限公司 备案号: 服务热线:18005415007 流量统计:

加拿大28预测神测网 极速赛车计划软件下载 极速赛车规律图全部 极速赛车技巧 极速赛车计划app下载 极速赛车精准计划全天在线 加拿大28APP下载 极速赛车规律破解 加拿大28预测神测网 彩票极速赛车规律破解